Bead Head Biot Body Golden Stone Nymph

Bead Head Golden Stone Nymph

Bead Head Golden Stone Nymph

 

Hook:
Head:
Thread:
Tail:
Abdomen:
Wing Case:
Legs:
Thorax:
2XL Nymph Hook #10
Gold Bead, Medium
Pale Yellow 6-0
Brown Goose Biots
Pale Morning Dun Turkey Biot
Pheasant Tail Fibers
Partridge feather
Golden Olive Superfine Dubbing

 

Step 1: Crimp the barb, add your bead and mount in your vise. I like to wrap a few turns of wire and slide it into the recess of the bead. If you want more weight, you can extend it further back. If you like, you can leave the weight off. Wrap the thread to the bend of the hook.

Step 1

Click to enlarge

Step 2: Tie in the tail biots. I’ve tried mounting them flat on top of the hook and on each side. In the end, I usually tie them in like this, about halfway between. I like the look on top, but it is a real pain to get them to stay in place. I tie both in at one time. Hold the biots convex side to convex side in my right hand to size the tail. Then transfer to my left hand to tie in. Two loose wraps to check the length and position, then tie down.

Step 2

Click to enlarge

Step 3: View from above.

Step 3

Click to enlarge

Step 4: I wrap the thread over the biots to the wire, then fold them back over the abdomen to make a mild taper, trimming them if they extend too far. Then lay a tapered thread base for the biot back to the rear.

Step 4

Click to enlarge

Step 5: Tie in the turkey biot so that the ridge will be to the left as you wrap it forward. This will produce the nice segmented abdomen. With this 2XL size 10 hook, it usually fits perfectly.

Step 5

Click to enlarge

Step 6: This shows the abdomen after wrapping the biot forward and tied off.

Step 6

Click to enlarge

Step 7: Tie in the pheasant tail fibers for the wing case. I use 8-10 fibers and tie them in by the butt.

Step 7

Click to enlarge

Step 8: Tie in the partridge feather. In this pattern, I want the legs to flow to the rear of the fly, so I tie the feather in by the tip. After it is pulled forward and tied down, the fibers will sweep back nicely. This also has the advantage of the thicker end being tied down in the front. So even if the tip breaks after a few fish, the feather will usually stay put by being anchored in front.

Step 8

Click to enlarge

Step 9:Dub a nice thorax. I try to make the abdomen and the thorax equal lengths behind the bead, so I went a little far on this fly. But I doubt the fish will notice.

Step 9

Click to enlarge

Step 10: Pull the partridge forward and hold down with two firm wraps. Then pull the pheasant tail fibers forward to make the wing case and tie down securely.

Step 10

Click to enlarge

Step 11: View from above.

Step 11

Click to enlarge

Step 12: Trim the butts and make a neat tie down. Whip finish and you are done. I don’t use any head cement of most of my flies, but feel free to use it if you like it.

Step 11

Click to enlarge

Step 13: Top View.

Step 13

Click to enlarge

Step 14: Bottom View.

Step 14

Click to enlarge

Step 15: Angled View. Give this fly a try. I think you will like it.

Bead Head Golden Stone Nymph

Click to enlarge